Dakota 4WD V8-318 5.2L (1991)
5.
Loosen steering column upper bracket nuts, but do not remove, then move upper fixed column cover to gain access to rear of multifunction switch.
6.
Remove multifunction switch mounting screws, then pull switch away from column.
7.
Loosen connector screws, then disconnect wiring connector from switch.
INSTALLATION
1.
Install wiring connector to switch and torque screws to 17 inch lbs.
2.
Mount multifunction switch to column and torque retaining screws to 17 inch lbs.
3.
Install upper fixed column cover and torque steering column upper bracket nuts to 110 inch lbs.
4.
Install lower fixed cover, then upper and lower lock covers.
5.
Install tilt lever, then connect battery ground cable, check all functions of switch.
