Dakota 4WD V8-4.7L VIN J (2007)
Cruise Control Servo: Service and Repair
Removal
REMOVAL
The speed control servo assembly (6) is attached to the right inner fender under the air cleaner filter housing.
1. Disconnect negative battery cable at battery.
2. Remove air cleaner filter housing assembly.
3. Disconnect vacuum line (1) at servo.
4. Disconnect electrical connector (5) at servo.
5. Remove three servo mounting screws (3).
6. Disconnect servo cable at throttle body.
Note: The servo and mounting bracket displayed is a typical unit.
7. Remove 2 mounting nuts (1) holding servo cable sleeve (4) to bracket.
8. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (3) and remove clip. Note: The servo
mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
9. Remove servo (2) from mounting bracket. While removing, note orientation of servo to bracket.