Dakota 4WD V8-4.7L VIN J (2007)
NOTE: The rear lamp unit contains two bulbs: park/stop/turn signal/side marker and backup. The service procedures for each bulb are the same, only
the bulb sizes and types may differ.
1. Align the base of the bulb with the park/stop/turn signal/side marker (2) or the backup (3) bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the rear lamp unit housing (1).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the wire harness connector (4) to the socket.
7. Reinstall the rear lamp unit onto the end of the quarter panel.
8. Reconnect the battery negative cable.
