Dakota 4WD V8-4.7L VIN J (2007)
Electronic Brake Control Module: Service and Repair
Removal
REMOVAL
NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type refer to
Differential and Driveline. For tire revolutions per mile. To program the ABM refer to the Appropriate Diagnostic Service Information.
1. Disconnect the pump electrical connector (3) from the HCU (2).
2. Remove the module mounting screws (1).
3. Remove the module (1) from the HCU (2).