Dakota 4WD V8-4.7L VIN J (2007)
Seat Belt Buckle Switch: Testing and Inspection
SEAT BELT SWITCH
Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of
wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable. Disconnect the seat belt switch pigtail wire connector from the seat wire harness connector for
the seat belt switch beneath the driver side front seat cushion forward of the seat belt buckle-half anchor. Check for continuity between the seat
belt switch sense circuit and the ground circuit cavities of the seat belt switch pigtail wire connector. There should be continuity with the seat belt
buckled, and no continuity with the seat belt unbuckled. If OK, go to STEP 2. If not OK, replace the ineffective front seat belt buckle-half
assembly.
2. Check for continuity between the ground circuit cavity in the seat wire harness connector for the seat belt switch and a good ground. There should
be continuity. If OK, go to STEP 3. If not OK, repair the open ground circuit to ground (G301) as required.
3. Remove the instrument cluster from the instrument panel. Check for continuity between the seat belt switch sense circuit cavity of the seat wire
harness connector for the seat belt switch and a good ground. There should be no continuity. If OK, go to STEP 4. If not OK, repair the shorted
seat belt switch sense circuit between the seat belt switch and the instrument cluster as required.
4. Check for continuity between the seat belt switch sense circuit cavities of the seat wire harness connector for the seat belt switch and the
instrument panel wire harness connector for the instrument cluster. There should be continuity. If OK, test and replace the ineffective instrument
cluster as required. If not OK, repair the open seat belt switch sense circuit between the seat belt switch and the instrument cluster as required.
