Dakota 4WD V8-4.7L VIN J (2007)
Washer Fluid Level Switch: Service and Repair
Installation
INSTALLATION
1. Install a new rubber grommet seal into the washer fluid level switch mounting hole in the outboard facing side of the combination washer
reservoir/coolant reserve bottle (1). Always use a new rubber grommet seal on the reservoir.
2. Insert the float of the switch (4) through the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly on the switch until the barbed nipple is fully seated in the rubber grommet seal in the reservoir. The
index notch should be at the top of the switch housing and engage the index rib molded into the reservoir above the switch mounting hole.
4. Reconnect the wire harness connector (5) to the switch connector receptacle.
5. Lower the vehicle.
6. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
7. Reconnect the battery negative cable.