Dakota 4WD V8-4.7L VIN J (2007)
9. Rotate pinion several times to ensure pinion bearings are seated.
10. Measure pinion torque to rotate (1) with an inch pound torque wrench (2). Pinion torque to rotate should be equal to recorded reading plus an
additional 0.56 Nm (5 in. lbs.).
If pinion torque to rotate is low, tighten pinion nut in 6.8 Nm (5 ft. lbs.) increments until pinion torque to rotating is achieved.
CAUTION: Never loosen pinion nut to decrease pinion bearing rotating torque. If pinion torque to rotating is exceeded, a new collapsible
spacer must be installed. Failure to follow these instructions will result in damage to the axle.
11. Install propeller shaft.
12. Install rear brake rotors components.