Removal and Installation of Wheel Cylinder for Dakota 4WD V8-47L VIN N (2000)
Wheel Cylinder: Service and Repair
Disassembly and Assembly
DISASSEMBLY
1. Remove push rods and boots.
2. Press pistons, cups and spring and expander out of cylinder bore.
3. Remove bleed screw.
ASSEMBLY
1. Lubricate wheel cylinder bore, pistons, piston cups and spring and expander with clean brake fluid.
2. Install first piston in cylinder bore. Then install first cup in bore and against piston. Be sure lip of piston cup is facing inward (toward spring and
expander) and flat side is against piston.
3. Install spring and expander followed by remaining piston cup and piston.
4. Install boots on each end of cylinder and insert push rods in boots.
5. Install cylinder bleed screw.
