Dakota 4WD V8-4.7L VIN N (2000)
Idler Pulley: Service and Repair
REMOVAL
1. Disconnect the negative battery cable from battery.
2. Remove the accessory drive belt.
Fig. 82
3. Remove the two bolts retaining the idler pulley assembly to the engine (Fig. 82).
INSTALLATION
1. Position the idler pulley assembly onto the engine and install the two retaining bolts. Tighten the bolts to 55 Nm (40 ft. lbs.).
2. Install the accessory drive belt.
3. Connect the negative battery cable.