dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Axle Shaft Assembly > < Front Axle, Right - Sounds During Acceleration
Page 1
background image

Axle Bearing: All Technical Service Bulletins
Front Axle, Right - Sounds During Acceleration

NUMBER: 03-06-00

GROUP: Axle

DATE: August 11, 2000

SUBJECT:
Sound Coming From The Front Axle During Acceleration At Vehicle Speeds between 5 to 30 MPH.

OVERVIEW:
This bulletin involves the replacement of the right side front axle bearing.

MODELS:
2000 (AN) Dakota
2000 (DN) Durango

NOTE:

THIS BULLETIN APPLIES TO FOUR WHEEL DRIVE VEHICLES.

SYMPTOM/CONDITION:
The customer may experience a repetitive whoop - whoop like sound coming from the front axle. There have been some complaints of a scrapping,
grinding, or chirping like sound that has been attributed to this condition. The sound will increase in frequency with vehicle speed. This sound will occur
only during vehicle acceleration and normally between the vehicle speeds of 8 to 48 kph (5 to 30 MPH). The sound may be more noticeable once the
front axle has reached normal operating temperature.

DIAGNOSIS:
Slowly accelerate the vehicle from a stop. If the sound is present during acceleration, then perform the Repair Procedure.

REPAIR PROCEDURE:

1.

Replace the right front (passenger side) axle shaft bearing. Refer to the 2000 Dakota Service Manual (Publication No. 81-370-0010) or the
Durango 2000 Service Manual (81-370-0016). Detailed technical instructions regarding the replacement of the Dakota right front axle shaft
bearing can be found on page 3-39 (Axle Shaft Seal and Bearing). Durango instructions can be found on page 3-38 of its respective manual.

PARTS REQUIRED:

EQUIPMENT REQUIRED:

2.

Once the axle has been reassembled, verify the correct front axle fluid level.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

FAILURE CODE: P8 - New Part

Axle Shaft Assembly > < Front Axle, Right - Sounds During Acceleration