Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
NOTE: Install a new copper washers on the banjo bolt when installing
4. Install the disc brake caliper (1) to the brake caliper adapter (2).
5. Install the banjo bolt (4) with new copper washers to the caliper (6). Tighten to 28 Nm (250 in. lbs.)
6. Install the caliper slide pin bolts (2). Tighten to 32 Nm (24 ft. lbs.)
7. Remove the prop rod from the brake pedal.
8. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.
9. Install the tire and wheel assembly.
10. Lower the vehicle.
Removal
REMOVAL
