Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
3. Install the brake line (2) to the axle stud.
4. Install the brake lines (1 & 3) into the brake hose (2).
5. Lower the vehicle and remove the support.
6. Remove the prop rod from the brake pedal.
7. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.
Front Caliper Hose
FRONT CALIPER HOSE
1. Install the brake hose (6) in position.
2. Install the mounting bracket bolt (3) at the frame, tighten to 14 Nm (125 in.lbs).
3. Install the brake line (1) into the junction block (2) and tighten to 14 Nm (125 in.lbs) If removed.
4. Install the brake line (1) into the brake hose (6) and tighten to 14 Nm (125 in.lbs).
5. Install the brake hose banjo bolt (4) Use new copper washers (5) at the caliper and tighten to 28 Nm (250 in.lbs).
6. Remove the support and lower the vehicle.
7. Remove the prop rod from the brake pedal.
8. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.