Dakota Quad Cab 2WD V6-3.9L VIN X (2002)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
RWAL Valve
Rwal Valve
REMOVAL
1. Disconnect the RWAL assembly harness connector from the RWAL assembly.
2. Remove the brake lines from the assembly.
3. Remove the assembly mounting bolt and remove the assembly from the vehicle.
INSTALLATION
1. Position the assembly on the inner fender well and install the mounting bolt. Tighten the mounting bolt to 20 - 27 Nm (15 - 20 ft. lbs.).
2. Install the brake lines and tighten to 19 Nm (170 inch lbs.).
3. Install the RWAL assembly harness connector into the RWAL assembly.
4. Bleed base brake system.