Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
2. Install lower exhaust manifold fasteners. DO NOT tighten until all fasteners are in place.
3. Lower vehicle and install upper exhaust manifold fasteners. Tighten all manifold bolts starting at center and working outward to 25 Nm (18 ft.
lbs.).
CAUTION: Over tightening heat shield fasteners, may cause shield to distort and/or crack.
4. Install exhaust manifold heat shield. Tighten fasteners to 8 Nm (72 inch lbs.), then loosen 45°.
5. Connect exhaust pipe to manifold.
6. Connect negative cable to battery.
