Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
Door Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.4 Driver Door Module
2. Using a trim stick or another suitable wide flat bladed tool and starting at the rear of the Driver Door Module (DDM) bezel, gently pry the DDM
up and out from the driver side front door trim panel.
3. Pull the DDM away from the trim panel opening far enough to access the two connector receptacles on the back of the unit.
4. Disconnect the two door wire harness connectors for the DDM from the DDM connector receptacles.
5. Remove the DDM from the door trim panel.
INSTALLATION
1. Position the Driver Door Module (DDM) to the opening in the driver side front door trim panel.
2. Reconnect the two door wire harness connectors for the DDM to the DDM connector receptacles.
3. Insert the front of the DDM bezel into the opening in the driver side front door trim panel.
4. Using hand pressure, gently and evenly press down on the rear of the DDM bezel until it snaps into place.
5. Reconnect the battery negative cable.
