Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
Central Timer Module ( CTM ) Low Option: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE
ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
NOTE: Before replacing a Central Timer Module (CTM), use a DRB III scan tool to retrieve the current settings for the CTM programmable
features. Refer to the appropriate diagnostic information. These settings should be duplicated in the replacement CTM using the DRB III scan tool
before returning the vehicle to service.
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the left cowl side inner panel.
Fig.2 Central Timer Module
3. Disconnect the two instrument panel wire harness connectors and one body wire harness connector from the CTM connector receptacles (Fig. 2).
4. Remove the three screws that secure the CTM to the left cowl side inner panel.
5. Remove the CTM from the left cowl side inner panel.
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE
ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
NOTE: Before replacing a Central Timer Module (CTM), use a DRB III scan tool to retrieve the current settings for the CTM programmable features.
Refer to the appropriate diagnostic information. These settings should be duplicated in the replacement high-line/premium CTM using the DRB III
scan tool before returning the vehicle to service.
1. Position the CTM onto the left cowl side inner panel (Fig. 2).
2. Install and tighten the three screws that secure the CTM to the left cowl side inner panel. Tighten the screws to 2 Nm (20 in. lbs.).
3. Reconnect the two instrument panel wire harness connectors and one body wire harness connector to the CTM connector receptacles.
4. Reinstall the trim onto the left cowl side inner panel.
5. Reconnect the battery negative cable.
