Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
-
Park lamp switch sense
-
Passenger door ajar switch sense
-
Passenger door switch MUX - high line with power locks only
-
PCI bus circuit
-
Radio control MUX - high-line with remote radio switches only
-
Washer switch sense
-
Wiper park switch sense
-
Wiper switch mode sense
-
Wiper switch mode signal
Hard Wired Outputs
The hard wired outputs of the CTM include the following:
-
Cargo lamp driver
-
Courtesy lamp driver
-
Door lock relay output - high-line with power locks only
-
Door unlock relay output - high-line with power locks only
-
Driver door unlock relay output
-
Fog lamp relay control - with fog lamps only
-
Front washer pump/motor control
-
Front wiper park switch sense
-
Front wiper relay control
-
Glove box lamp driver
-
High beam indicator driver
-
Horn relay control - high-line with power locks only
-
Interior lamp driver
-
Left high beam driver
-
Left low beam driver
-
Park lamp relay control
-
Right high beam driver
-
Right low beam driver
-
VTSS indicator driver - high-line with VTSS only
Messaging
The CTM uses the following messages received from other modules over the PCI data bus:
-
Airbag Deploy (ACM)
-
Beep request (CMTC)
-
Charging System Failure (PCM)
-
Chime request (EMIC)
-
Engine RPM (PCM)
-
OK to Arm VTSS (PCM)
-
Security indicator request (SKIM)
-
System Voltage (PCM)
-
Valid/Invalid Key (SKIM)
-
Vehicle Distance (PCM)
-
Vehicle Speed (PCM)
-
Voltage Fault (PCM)
The CTM provides the following messages to other electronic modules over the PCI data bus:
-
Door Ajar Status (EMIC)
-
Park Brake Status (CAB, EMIC, TCM)
-
Radio Mode (Radio)
-
Radio Preset Scan (Radio)
-
Radio Seek Down (Radio)
-
Radio Seek Up (Radio)
-
Radio Volume Down (Radio)
-
Radio Volume Up (Radio)
-
Ignition Staus
-
VTSS Status
-
Country Code