Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
6. Remove the mounting bolts from the gear to the front crossmember and remove the gear.
INSTALLATION
NOTE: Before installing gear inspect bushings and replace if worn or damaged.
1. Install gear on front crossmember and tighten mounting bolts to 271 Nm (200 ft. lbs.).
2. Slide shaft coupler onto gear. Install new bolt and tighten to 49 Nm (36 ft. lbs.).
3. Clean tie rod end studs and knuckle tapers.
4. Install tie rod ends into the steering knuckles and tighten the nuts to 81 Nm (60 ft. lbs.).
5. Install power steering lines to steering gear and tighten the hose to 31 Nm (23 ft. lbs.).
6. Remove support and lower vehicle.
7. Fill system with fluid.
8. Adjust the toe position.
