Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Clutch: Service and Repair
Rear Clutch
Disassembly
46RE - Automatic Transmission
REAR CLUTCH
DISASSEMBLY
1. Remove fiber thrust washer from forward side of clutch retainer.
2. Remove input shaft front and rear seal rings.
3. Remove selective clutch pack snap-ring (Fig. 230).
4. Remove the reaction plate, clutch discs, steel plates, pressure plate, wave spring, spacer ring, and piston spring (Fig. 230).
5. Remove clutch piston with rotating motion.
6. Remove and discard piston seals.
7. Remove input shaft retaining ring. It may be necessary to press the input shaft in slightly to relieve tension on the retaining ring
8. Press input shaft out of retainer with shop press and suitable size press tool. Use a suitably sized press tool to support the retainer as close to the
input shaft as possible.
Cleaning and Inspection
46RE - Automatic Transmission
REAR CLUTCH
CLEANING
Clean the clutch components with solvent and dry them with compressed air. Do not use rags or shop towels to dry any of the clutch parts. Lint from
such materials will adhere to component surfaces and could restrict or block fluid passages after assembly.
INSPECTION
Replace the clutch discs if warped, worn, scored, burned/charred, the lugs are damaged, or if the facing is flaking off. Replace the top and bottom