Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Output Shaft: Service and Repair
Output Shaft Rear Bearing
REMOVAL
1. Remove overdrive unit from the vehicle.
2. Remove overdrive geartrain from housing.
3. Remove snap-ring holding output shaft rear bearing into overdrive housing (Fig. 125).
4. Using a suitable driver inserted through the rear end of housing, drive bearing from housing.
INSTALLATION
1. Place replacement bearing in position in housing.
2. Using a suitable driver, drive bearing into housing until the snap-ring groove is visible.
3. Install snap-ring to hold bearing into housing (Fig. 122).
4. Install overdrive geartrain into housing.