Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Output Shaft Bearing/Bushing: Service and Repair
42/44RE (A-500) 4 Speed
Output Shaft Front Bearing
42RE - Automatic Transmission
Output Shaft Front Bearing
REMOVAL
1. Remove overdrive unit from the vehicle.
2. Remove overdrive geartrain from housing.
3. Remove snap-ring holding output shaft front bearing to overdrive geartrain. (Fig. 121).
4. Pull bearing from output shaft.
INSTALLATION
1. Place replacement bearing in position on geartrain with locating retainer groove toward the rear.
2. Push bearing onto shaft until the snap-ring groove is visible.
3. Install snap-ring to hold bearing onto output shaft.
4. Install overdrive geartrain into housing.
5. Install overdrive unit in vehicle.
Output Shaft Rear Bearing
42RE - Automatic Transmission
Output Shaft Rear Bearing
REMOVAL
1. Remove overdrive unit from the vehicle.
2. Remove overdrive geartrain from housing.