Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
UPPER AND LOWER HOUSING
1. Position upper housing so internal passages and check ball seats are facing upward. Then install check balls in housing (Fig. 320). Eight check
balls are used. The single large check ball is approximately 8.7 mm (11/32 inch) diameter. The single small check ball is approximately 4.8 mm
(3/16 inch) in diameter. The remaining 6 check balls are approximately 6.3 mm (1/4 inch) in diameter.
2. Position assembled transfer plate and upper housing separator plate on upper housing (Fig. 321). Be sure filter screen is seated in proper housing
recess.
3. Install the Number 10 check ball into the transfer plate (Fig. 322). The check ball is approximately 4.8 mm (3/16 inch) in diameter.