Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
5. Install nuts that hold clutch master cylinder to dash panel. Tighten nuts to 54 Nm (40 ft. lbs.).
6. Apply light coating of grease to the inner diameter of the master cylinder push-rod and the outer diameter of the clutch pedal pin.
7. Install clutch master cylinder push rod on clutch pedal pin. Secure rod with retaining clip.
8. Connect clutch pedal position switch connector from wiring harness.
9. Raise vehicle.
10. Insert slave cylinder push rod through clutch housing opening and into release lever. Be sure end of rod is securely engaged in release lever. Check
this before installing cylinder attaching nuts.
NOTE: If new clutch linkage is being installed, do not remove plastic shipping strap from the slave cylinder push rod. The strap will break on its own
upon first clutch application.
11. Install and tighten slave cylinder attaching nuts to 23 Nm (200 inch lbs.).
12. Install hydraulic fluid line clip into the hole in the lower dash panel flange.
13. Verify that fluid line from master cylinder to slave cylinder is properly routed.
