Dakota Quad Cab 4WD V6-3.9L VIN X (2001)
Low Pressure Sensor / Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the loss of charge switch on the top of the accumulator.
3. Unscrew the loss of charge switch from the fitting on the top of the accumulator.
4. Remove the O-ring seal from the accumulator fitting and discard.
INSTALLATION
1. Lubricate a new O-ring seal with clean refrigerant oil and install it on the accumulator fitting. Use only the specified O-rings as they are made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
2. Install and tighten the loss of charge switch on the accumulator fitting. The switch should be hand-tightened onto the accumulator fitting.
3. Plug the wire harness connector into the loss of charge switch.
4. Connect the battery negative cable.
