Dakota R/T 2WD V8-5.9L VIN Z (1998)
Fog/Driving Lamp Switch: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel. See Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Cluster Bezel in the
Replacement for the procedures.
Lamp Switch Remove/Install
3. From the back side of the cluster bezel, squeeze the tabs on the back of the fog lamp switch that secure it in the receptacle on the back of the bezel.
4. Pull the fog lamp switch out of the receptacle on the back of the cluster bezel.
5. Reverse the removal procedures to install. Be certain that the fog lamp switch latches are fully engaged in the cluster bezel receptacle.