Daytona IROC V6-181 3.0L SOHC VIN 3 FI (1992)
P Seals, Escutheons And Outer Mouldings
"P" SEALS, ESCUTCHEONS, AND OUTER MOULDINGS
1. Remove and protect glass assemblies from damage.
2. Drill out rivets in moulding retainers with 1/8 inch drill bit.
3. Remove "P" seals by pulling free.
4. Using retained "P" seals as patterns, cut "V" cuts into new "P" seals, then discard old seals.
5. If outer mouldings are to be replaced, pry carefully away from body.
6. Seal rivet holes with butyl sealant.
7. To install, reverse above procedure.
Locks, Side Rail Seals, And Glass Panels
SIDE RAIL SEALS
Removal
1. Remove glass panels, place on soft surface.
2. Spray an adhesive release agent under edge of seal and let soak.
3. Remove two screws at ends of weatherstrip.
4. Remove seal.
5. Clean remaining excess sealant from seal area.
Installation
1. Apply weatherstrip adhesive to back of new seal.
2. Position seal and install two screws.
3. Seal ends of new seal by applying an 1/8 inch bead of silicone around entire perimeter of end tabs, and smooth with finger.
4. Adjust seals and rods as necessary to make a seal around entire hatch and door glass.
DOOR FRAME SEALS
Removal and Installation
1. Remove three screws from front seal.
2. Remove two screws from back seal.
3. Lift off seals.
4. To install, reverse above procedure.
