Daytona IROC R/T L4-135 2213cc 2.2L DOHC Turbo VIN A FI (1993)
Drive Belt: All Technical Service Bulletins
Serpentine Belt - Comes Off Pulleys, Driving in Snow
NO: 07-03-94 Rev. A
GROUP: Cooling
DATE: Dec. 30, 1994
SUBJECT:
Serpentine Belt Comes Off Pulleys
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 07-03-94 DATED FEB. 25, 1994 WHICH SHOULD BE REMOVED FROM
YOUR FILES. REVISIONS ADD 1995 MODELS, ES VEHICLES, CHANGE IN THE REPAIR PROCEDURE, TIME ALLOWANCE AND
UPDATES THE PART NUMBERS. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS**.
MODELS:
1991 - **1995**
(AA) Spirit/Acclaim/LeBaron Sedan
1991 - 1993
(AC) Dynasty/New Yorker/New Yorker Salon
1991 - **1993**
(AG) Daytona
1991 - **1995**
(AJ) LeBaron Coupe/LeBaron Convertible
1992 - **1994**
(AP) Shadow/Shadow Convertible/Sundance
1991 - **1995**
(AS) Caravan/Voyager
**1992 - 1995
(ES) Chrysler Voyager (European Market)**
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 3.0L ENGINE.
SYMPTOM/CONDITION:
When driving a vehicle through deep snow, the serpentine belt may be forced off the pulleys. The first indication to the driver this has happened is a low
voltage condition being indicated by the voltmeter or battery light being illuminated.
DIAGNOSIS:
Inspect all belt driven accessories and associated pulleys for proper alignment and attachment. If alignment and attachment are correct, perform the
repair procedure.
PARTS REQUIRED:
1
**4673254**
Shield
2
6030441
Retainers
1
**6035135**
Screw
**AR
4612829
Belt, Serpentine Drive**
REPAIR PROCEDURE:
This bulletin involves installing a shield to prevent snow from coming in contact with the serpentine belt.
**PROCEDURE FOR AA. AC. AG. AJ. AND AP VEHICLES:
1.
Raise the vehicle on an appropriate hoist.
2.
Re-install the serpentine drive belt, P/N 4612829, or replace if the belt is damaged.
3.
Position the new additional shield, P/N 4673254, over the right driveshaft and below the serpentine belt.
4.
Install 2 new retainers, P/N 6030441, to secure the rear of the crankshaft pulley shield and the front of the new additional shield.
5.
Using screw, P/N 6035135, and the existing hole in the frame rail, attach the upper mounting tab of the shield to the frame rail.
6.
Lower the vehicle.
PROCEDURE FOR AS AND ES VEHICLES:
1.
Raise the vehicle on an appropriate hoist.