Durango 2WD V6-3.7L (2009)
NOTE: For mount to engine block and left engine bracket to front axle bolts, apply Mopar(R) Lock & Seal Adhesive.
1. Install the right and left side engine mount brackets (2) to the engine.
2. Install the right and left side engine mounts to the front axle. Tighten the nuts to 94 Nm (70 ft. lbs.).
3. Raise the front axle into the frame and install the left and right side through bolts. Tighten nuts to 94 Nm (70 ft. lbs.).
4. Insert the two upper through bolts into the right and left side engine mounts and loose assemble the two nuts onto the through bolts.
5. Lower the engine using the Engine Support 8534B (1) until the left and right side engine brackets rest on the through bolts, and the lower engine
bracket through holes align with the engine mounts, and the left engine bracket holes align with the front axle slots.
6. Loose assemble the bolts that attach the front axle to the left engine bracket.
7. Loose assemble the lower through bolts.
8. Tighten the nuts for the through bolts to 101 Nm (75 ft. lbs.).
9. Tighten the bolts that attach the front axle to the left engine bracket to 101 Nm (75 ft. lbs.).
10. Install the oil drain trough.
11. Install the engine oil filter.
12. Install the cooling fan.
13. Reconnect the negative battery cable.
