Durango 2WD V6-3.7L (2009)
Front Crankshaft Seal: Service and Repair
Front Crankshaft Oil Seal - Removal
REMOVAL
1. Disconnect negative cable from battery.
2. Remove the accessory drive belt. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Removal
3. Remove A/C compressor mounting fasteners and set the compressor aside. See: Heating and Air Conditioning/Compressor HVAC/Service and
Repair/A/C Compressor - Removal
4. Drain the cooling system. See: Cooling System/Service and Repair
5. Remove the upper radiator hose.
6. Disconnect the electrical connector for fan mounted inside radiator shroud.
7. Remove the radiator cooling fan. See: Cooling System/Radiator Cooling Fan
8. Remove crankshaft damper bolt.
9. Remove damper using Crankshaft Insert 8513A (1) and Three Jaw Puller 1026 (2).
10. Using the Seal Remover 8511 (1), remove crankshaft front seal.