Durango 2WD V6-3.7L (2009)
3. Learn ETC
4. Check PCM Odometer
5. Check PCM VIN - if NOT WCM equipped
6. TCM Quicklearn - if EATX equipped
If a CVT TCM was replaced, perform the following additional steps and/or routines:
1. Initialize CVT
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
STEP-BY-STEP INSTRUCTIONS
Check PCM Odometer
From the "Home" screen, select "ECU View".
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Check PCM Odometer" and follow the on screen instructions.
-
When complete, select "Finish".
Check PCM VIN
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Check PCM VIN" and follow the on screen instructions.
-
When complete, select "Finish"
Initialize CVT
From the "Home" screen, select "ECU View"
-
Select "TCM"
-
Select "Misc. Functions"
-
Select "Initialize CVT" and follow the on screen instructions.
-
When complete, select "Finish"
Initialize EGS
From the "Home" screen, select "ECU View"
-
Select "TCM"
-
Select "Misc. Functions"
-
Select "Initialize EGS" and follow the on screen instructions.
-
When complete, select "Finish"
Learn ETC
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Learn ETC" and follow the on screen instructions.
-
When complete, select "Finish"
PCM Replaced
The vehicle pin (Personal Identification Number) will be required to complete the routine. This information may be obtained in three ways:
1. The original selling invoice
2. Dealer CONNECT > Parts > Key Codes