Durango 2WD V6-3.7L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System Module - Installation
INSTALLATION
CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before
removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do
not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and
issues in the future.
1. Position the module on the HCU on ESP vehicles be careful not to damage the pressure sensor or not to touch the sensor terminals on the
HCU side or the contact pads on the ABM side when installing the ABM.
2. Install the mounting screws (2) and tighten to 2.5 Nm (22 in. lbs).
3. Connect the scan tool and initialize the ABM by performing the ABS Verification Test See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test.
