Durango 2WD V6-3.7L (2009)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Removal
REMOVAL
1. Disconnect negative cable from battery.
2. Remove the steering column opening cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Steering Column Opening Cover - Removal.
3. Remove the tilt lever handle.
4. Remove the lower shroud (2) from steering column.
5. Place shifter in PARK position.
The ignition key (2) must be in the key cylinder (1) for cylinder removal.
6. A retaining pin is located at side of key cylinder assembly.
a. Rotate key (2) to RUN position.
b. Press in on retaining pin with a small punch (3) , while pulling key cylinder (1) from ignition switch.