Durango 2WD V6-3.7L (2009)
Window Track: Service and Repair
Door Glass Channel - Removal
REMOVAL
1. Raise the glass to the full up position.
2. Remove the watershield. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door Water
Shield - Removal.
3. Remove the nuts (2) and disconnect the electrical connector (3), if equipped.
4. Remove the side view mirror (1).
5. Separate the inner belt molding from the mounting flange, (from the rear to the front).
6. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
7. Push down on outer belt molding (1) and rotate the upper part of the tool (2) outward from the vehicle, then lift up on the molding (1) to disengage
from the locking tabs (3), working from back to front.
NOTE: Typical outer belt molding design shown.