Durango 2WD V6-3.7L (2009)
2. Bead dimensions should be approximately 9.5 - 12.0 mm wide (1) by 12.7 - 14.0 mm in height (2).
3. Allow end of adhesive bead to run out parallel to the start of the bead and smooth ends flush.
4. Lift windshield into place in the center of the windshield opening and use the tape as a guide to aid installation of the windshield into the center of
the cutout.
5. Carefully lay down windshield and press on.
CAUTION: It is no longer possible to move the windshield after installation. The windshield should never be pressed into place by more than
one person, because the windshield can break if pressed simultaneously on both sides.
CAUTION: Roll down the left and right front door glass and open the rear glass slider (if available) before installing windshield to avoid
pressurizing the passenger compartment if a door is slammed before urethane is cured. Water leaks can result.
6. Install cowl grille. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Cover - Installation
7. Install rear view mirror. See: Body and Frame/Mirrors/Service and Repair/Interior Rearview Mirror - Installation
