Durango 2WD V8-4.7L (2008)
Power Trunk / Liftgate Control Module: Service and Repair
Installation
INSTALLATION
1. Position the power liftgate control module (4) into the vehicle.
2. Insert the mounting tab into the locating slot (3) on the quarter panel.
3. Tilt the top of the module (4) toward the quarter panel and firmly press the clip (1) into the retaining hole on the quarter panel.
4. Connect the wire harness connectors (2) to the power liftgate control module (4).
5. Install the left quarter trim panel, See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel Trim/Quarter Trim
Panel - Installation.
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
8. Perform the power liftgate learn cycle, See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Procedures/Power
Liftgate Learn Cycle.
9. Verify power liftgate system operation.