Durango 2WD V8-4.7L Flex Fuel (2009)
Vacuum Brake Booster Diaphragm Position Sensor: Service and Repair
Travel Sensor - Installation
INSTALLATION
NOTE: When replacing the travel sensor, the Anti-Lock Brake Module (ABM) must be initialized using the scan tool. To initialize the ABM
perform the ABS VERIFICATION TEST - HEV. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test .
NOTE: Verify that the surface is clean, the old O-ring is removed, and the new O-ring is properly positioned on the sensor.
1. With a slight twisting motion, push the travel sensor (3) into the power brake booster (1). There should be a slight snapping sound as the retainer
clip (3) seats into position.
2. Verify that the travel sensor retainer clip (3) snapped into place.
3. Connect the electrical connector (2) to the travel sensor (1).
