Durango 2WD V8-4.7L Flex Fuel (2009)
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove right rear quarter panel trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment
Trim/Quarter Trim Panel - Removal.
3. Disconnect the rear heater-A/C wire harness connector (1) from the rear mode door actuator (4) located on the inboard side of the rear heater-A/C
housing (3).
4. Remove the two screws (2) that secure the rear mode door actuator to the rear heater-A/C housing and remove the actuator.
Front
INSTALLATION
1. Position the mode door actuator(s) (1) onto the driver side end of the HVAC housing as required. If necessary, rotate the actuator slightly to align
the splines on the actuator output shaft with those in the mode-air door linkage.