Durango 2WD V8-4.7L Flex Fuel (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Installation
INSTALLATION
1. Install the heated seat module on the D-pillar (1).
2. Connect the wire harness connector (3) to the heated seat module (2).
3. Reconnect the negative battery cable.
4. Check for proper heated seat system operation.
5. Install the upper and lower D-pillar trim to the vehicle. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/D-Pillar Trim/Installation.
6. Connect the battery negative cable.
