Durango 2WD V8-4.7L Flex Fuel (2009)
Trunk / Liftgate Switch: Service and Repair
Overhead Console Switch - Installation
INSTALLATION
DURANGO
1. Position the power liftgate switch into the overhead console assembly so that the large retaining tab (2) is aligned with the large slot between the
reading lamps.
2. Gently press the power liftgate switch (1) into the overhead console assembly (3) until the two small mounting tabs (2) have snapped securely into
place.
3. Install the overhead console assembly (3), See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console -
Installation.
4. Connect the battery negative cable.
5. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
6. Verify power liftgate system operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate
control module to relearn its cycle with the new components.
ASPEN