Durango 2WD V8-4.7L Flex Fuel (2009)
Wiper Gear Box: Service and Repair
Wiper Transmission - Removal
REMOVAL
NOTE: The front wiper motor can be removed from the wiper module without removing the module from the vehicle, and is available as a
separate service component for this vehicle. See: Wiper Motor/Service and Repair/Wiper Motor - Removal .
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove both front wiper arms from the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arm - Removal.
3. Remove the cowl plenum cover/grille panel from over the front wiper module. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair/Cowl Panel Cover - Removal.
4. Disconnect the wire harness connector (5) from the front wiper motor connector.
5. Remove the screw (3) that secures the front wiper module bracket (6) and the center bracket of the cowl grille support (7) to the cowl plenum
panel (1).
6. Remove the three screws (2) that secure the module bracket to the cowl plenum panel and the left front fender ledge.
7. Remove the wiper module from the engine compartment as a unit.