Durango 2WD V8-4.7L VIN N (2001)
7. Remove radiator upper mounting screws. Lift radiator upward and away from vehicle. Do not allow cooling fins of radiator to contact any other
vehicle component. Radiator fin damage could result.
INSTALLATION
The radiator has two isolator pins on bottom of both tanks. These fit into alignment holes in radiator lower support.
1. Position isolator pins into alignment holes in radiator lower support.
2. Install and tighten radiator mounting bolts to 23 Nm (200 inch lbs.).
3. Install the transmission oil cooler lines, (if equipped).
4. Connect fan motor electrical connector to harness connector.
5. Position upper fan shroud onto lower fan shroud and radiator.
6. Install retaining screws into shroud.
7. Install radiator hoses. reconnect coolant reserve/overflow tank hose.
8. Connect battery negative cable.
9. Fill cooling system.
10. Start and warm the engine. Check for leaks.
