Durango 2WD V8-4.7L VIN N (2001)
Fig. 5 Rear Seat Floor Ducts Remove/Install - Split Bench Seat
2. Remove the retainers that secure the ducts to the floor panel transmission tunnel
3. Remove the duct(s) from the floor panel as required.
INSTALLATION
Split Bench Seat
1. Install the bezel to the back of the front seat far enough to allow access to engage the control cable retainer and cable end to the controller.
2. Install the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center.
Bucket Seat
1. Assemble the floor console as required to install duct and control assembly.
2. Install floor console into vehicle.
3. Reach through the top of the console to engage the control rod end to the floor duct damper door pivot.
4. Install the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center.
Rear Seat Floor Duct
1. Install the duct(s) to the floor panel as required.
2. Install the retainers that secure the ducts to the floor panel transmission tunnel.
3. Install the carpeting to the floor panel transmission tunnel.
