Durango 2WD V8-4.7L VIN N (2001)
Blower Motor: Service and Repair
Rear Blower Motor
REMOVAL
The rear blower motor is used only on models with the optional rear heater-A/C unit. Because the rear blower motor and wheel are factory balanced
units, the rear blower motor, wheel, housing and mounting hardware are serviced only as a complete unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the right rear inside trim panel from the passenger compartment of the vehicle. Refer to Body for the procedures.
3. Unplug the motor connector.
4. Remove the three blower motor retaining screws.
5. Remove the blower motor from the rear heater- A/C housing.
INSTALLATION
The rear blower motor is used only on models with the optional rear heater-A/C unit. Because the rear blower motor and wheel are factory balanced
units, the rear blower motor and wheel are serviced only as a complete unit.
1. Position the rear blower motor and wheel to the rear heater-A/C unit, and start the three mounting screws to hold it in position.
2. Engage the rear A/C unit wire harness in the routing holes on each end of the blower housing.
3. Finish installing the three rear blower motor and wheel mounting screws. Tighten the mounting screws to 3 Nm (27 in. lbs.).
4. Plug in the rear blower motor wire harness connector.
5. Connect the battery negative cable.