Durango 2WD V8-4.7L VIN N (2001)
Fig. 7 RWAL Controller
3. Remove the controller mounting screws and remove the controller from the mounting bracket.
INSTALLATION
NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new CAB.
1. Position the controller on the bracket.
2. Install the mounting screws and tighten to 6 Nm (53 in. lbs).
3. Install the RWAL valve harness connector into the controller.
4. Install the CAB harness connector into the controller and push down on the connector lock.
