Durango 2WD V8-4.7L VIN N (2001)
Alternator: Service and Repair
REMOVAL
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE)
FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.
1. Disconnect negative battery cable at battery.
2. Remove generator drive belt.
3. Unsnap plastic cable protector cover from B+ mounting stud.
Fig. 3 Remove/Install Generator
4. In this engine: Remove 3 generator mounting bolts (Fig. 3). Position generator for access to wire connectors.
Fig. 4 Generator Connectors - Typical Denso
5. Remove B+ terminal mounting nut at rear of generator (Fig. 4). Disconnect terminal from generator.
6. Disconnect field wire connector at rear of generator by pushing on connector tab and pulling connector from generator.