Durango 2WD V8-5.2L VIN Y (1999)
Lock Cylinder Switch: Service and Repair
REMOVAL AND INSTALLATION
Door Lock Cylinder Switch
1. Disconnect and isolate the battery negative cable.
2. Remove the door outside latch handle mounting hardware and linkage from the inside of the door.
Door Lock Cylinder Switch Remove/Install - Typical
3. From the outside of the door, pull the door outside latch handle out far enough to access the door lock cylinder switch.
4. Disengage the door lock cylinder switch from the back of the lock cylinder.
5. Unplug the door lock cylinder switch wire harness connector.
6. Disengage the retainers that secure the door lock cylinder switch wire harness to the inner door panel.
7. Remove the door lock cylinder switch from the door.
8. Reverse the removal procedures to install.
Liftgate Lock Cylinder Switch
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the liftgate inner panel.
Liftgate Lock Cylinder Switch Remove/Install
3. Reach through the access hole in the liftgate inner panel to disengage the switch from the back of the liftgate lock cylinder.
4. Unplug the liftgate lock cylinder switch wire harness connector.
5. Remove the liftgate lock cylinder switch from the liftgate.
6. Reverse the removal procedures to install.
