Durango 2WD V8-5.2L VIN Y (1999)
Fig. 10 Trim Panel Retainer
5. Simultaneously lift upward and outward to release retainer steps from inner door panel.
6. Disengage inside handle linkage rod from inside handle.
Fig. 42 Power Window/Lock Connector
7. Disconnect power window/lock harness connector, if equipped.
8. Separate door trim panel from vehicle.
9. If necessary, pull upper trim extension outward to disengage from rear door.
INSTALLATION
1. If removed, install upper trim extension on rear door.
2. Position trim panel at door.
3. Engage harness connector for power window/lock, if equipped.
4. Engage inside handle linkage rod to inside handle.
5. Align trim panel retainer steps with inner door panel and slide trim panel into place.
6. Install screws attaching trim panel to door.
7. Install window crank, if equipped.
Heat Staking
STANDARD PROCEDURE - HEAT STAKING
1. Remove trim panel.
2. Bend or move the trim panel components at the heat staked joints. Observe the heat staked locations and/or component seams for looseness.