Durango 2WD V8-5.2L VIN Y (1999)
Brake Drum: Testing and Inspection
The maximum allowable diameter of the drum braking surface is indicated on the drum outer edge. Generally, a drum can be machined to a maximum
of 1.52 mm (0.060 inch) oversize. Always replace the drum if machining would cause drum diameter to exceed the size limit indicated on the drum.
BRAKE DRUM RUNOUT
Measure drum diameter and runout with an accurate gauge. The most accurate method of measurement involves mounting the drum in a brake lathe
and checking variation and runout with a dial indicator.
Variations in drum diameter should not exceed 0.076 mm (0.003 inch). Drum runout should not exceed 0.20 mm (0.008 inch) out of round. Machine
the drum if runout or variation exceed these values. Replace the drum if machining causes the drum to exceed the maximum allowable diameter.
