Durango 2WD V8-5.2L VIN Y (1999)
Cowl Plenum Cover/Grille Panel Remove/Install
4. Remove four plastic nuts securing cowl plenum cover/grille panel to studs on cowl top panel near base of windshield.
5. Remove two plastic rivets securing each side of the cowl plenum cover/grille panel to cowl plenum panel and cowl top panel.
6. Lift cowl plenum cover/grille panel from vehicle far enough to access windshield washer and vacuum plumbing near right end of cowl plenum.
7. Disconnect windshield washer supply hose at in-line connector.
Vacuum Reservoir Mounting
8. Disconnect vacuum supply hose from vacuum supply connector at vacuum reservoir.
9. Remove cowl plenum cover/grille panel from vehicle.
10. Remove three reservoir mounting screws.
11. Remove vacuum reservoir from vehicle.
INSTALLATION
1. Install vacuum reservoir and three mounting screws to plastic cowl cover. Tighten three screws to 2.2 N.m (20 in. lbs.) torque.
