Durango 2WD V8-5.2L VIN Y (1999)
Injector Retaining Clips - Typical Injector
12. Remove clip(s) retaining injector(s) to fuel rail.
INSTALLATION
1. Apply a small amount of clean engine oil to each fuel injector O-ring. This will help in fuel rail installation,
2. Install injector(s) and injector clip(s) to fuel rail,
3. Position fuel rail/fuel injector assembly to injector openings on intake manifold.
4. Guide each injector into intake manifold. Be careful not to tear injector O-ring.
5. Push right fuel rail down until fuel injectors have bottomed on injector shoulder. Push left fuel rail down until fuel injectors have bottomed on
injector shoulder.
6. Install fuel rail mounting bolts.
7. Connect electrical connector to intake manifold air temperature sensor.
8. Connect wiring to all fuel injectors. The injector wiring harness is numerically tagged.
9. Install A/C support bracket (if equipped).
10. Install throttle body to intake manifold. Refer to Throttle Body installation.
11. Install fuel tube (line) at side of fuel rail. Refer to Quick-Connect Fittings for procedures.
12. Install air cleaner.
13. Connect battery cable to battery.
14. Start engine and check for leaks.